accel/habanalabs: disable device access after CPLD_SHUTDOWN

After a CPLD shutdown event the device becomes unusable. Prevent further
device access once this event is received.

Signed-off-by: Konstantin Sinyuk <konstantin.sinyuk@intel.com>
Reviewed-by: Koby Elbaz <koby.elbaz@intel.com>
Signed-off-by: Koby Elbaz <koby.elbaz@intel.com>

2 files changed, 28 insertions, 0 deletions

diff --git a/drivers/accel/habanalabs/common/device.c b/drivers/accel/habanalabs/common/device.c
index 80fa08bf57bd..c6830c8026ac 100644
--- a/drivers/accel/habanalabs/common/device.c
+++ b/drivers/accel/habanalabs/common/device.c
@@ -1630,6 +1630,11 @@ int hl_device_reset(struct hl_device *hdev, u32 flags)
 	from_watchdog_thread = !!(flags & HL_DRV_RESET_FROM_WD_THR);
 	reset_upon_device_release = hdev->reset_upon_device_release && from_dev_release;
 
+	if (hdev->cpld_shutdown) {
+		dev_err(hdev->dev, "Cannot reset device, cpld is shutdown! Device is NOT usable\n");
+		return -EIO;
+	}
+
 	if (!hard_reset && (hl_device_status(hdev) == HL_DEVICE_STATUS_MALFUNCTION)) {
 		dev_dbg(hdev->dev, "soft-reset isn't supported on a malfunctioning device\n");
 		return 0;
@@ -2576,6 +2581,14 @@ void hl_device_fini(struct hl_device *hdev)
 	if (rc)
 		dev_err(hdev->dev, "hw_fini failed in device fini while removing device %d\n", rc);
 
+	/* Reset the H/W (if it accessible). It will be in idle state after this returns */
+	if (!hdev->cpld_shutdown) {
+		rc = hdev->asic_funcs->hw_fini(hdev, true, false);
+		if (rc)
+			dev_err(hdev->dev,
+				"hw_fini failed in device fini while removing device %d\n", rc);
+	}
+
 	hdev->fw_loader.fw_comp_loaded = FW_TYPE_NONE;
 
 	/* Release kernel context */
@@ -2943,3 +2956,15 @@ void hl_handle_clk_change_event(struct hl_device *hdev, u16 event_type, u64 *eve
 
 	mutex_unlock(&clk_throttle->lock);
 }
+
+void hl_eq_cpld_shutdown_event_handle(struct hl_device *hdev, u16 event_id, u64 *event_mask)
+{
+	hl_handle_critical_hw_err(hdev, event_id, event_mask);
+	*event_mask |= HL_NOTIFIER_EVENT_DEVICE_UNAVAILABLE;
+
+	/* Avoid any new accesses to the H/W */
+	hdev->disabled = true;
+	hdev->cpld_shutdown = true;
+	hl_cn_hard_reset_prepare(hdev);
+	hl_cn_stop(hdev);
+}
diff --git a/drivers/accel/habanalabs/common/habanalabs.h b/drivers/accel/habanalabs/common/habanalabs.h
index 122ade172bb4..33aa385c2693 100644
--- a/drivers/accel/habanalabs/common/habanalabs.h
+++ b/drivers/accel/habanalabs/common/habanalabs.h
@@ -3386,6 +3386,7 @@ struct eq_heartbeat_debug_info {
  *                    addresses.
  * @is_in_dram_scrub: true if dram scrub operation is on going.
  * @disabled: is device disabled.
+ * @cpld_shutdown: is cpld shutdown.
  * @late_init_done: is late init stage was done during initialization.
  * @hwmon_initialized: is H/W monitor sensors was initialized.
  * @reset_on_lockup: true if a reset should be done in case of stuck CS, false
@@ -3562,6 +3563,7 @@ struct hl_device {
 	u16				cpu_pci_msb_addr;
 	u8				is_in_dram_scrub;
 	u8				disabled;
+	u8				cpld_shutdown;
 	u8				late_init_done;
 	u8				hwmon_initialized;
 	u8				reset_on_lockup;
@@ -4119,6 +4121,7 @@ void hl_init_cpu_for_irq(struct hl_device *hdev);
 void hl_set_irq_affinity(struct hl_device *hdev, int irq);
 void hl_eq_heartbeat_event_handle(struct hl_device *hdev);
 void hl_handle_clk_change_event(struct hl_device *hdev, u16 event_type, u64 *event_mask);
+void hl_eq_cpld_shutdown_event_handle(struct hl_device *hdev, u16 event_id, u64 *event_mask);
 
 #ifdef CONFIG_DEBUG_FS