diff options
Diffstat (limited to 'Documentation/admin-guide/mm/pagemap.rst')
| -rw-r--r-- | Documentation/admin-guide/mm/pagemap.rst | 201 |
1 files changed, 201 insertions, 0 deletions
diff --git a/Documentation/admin-guide/mm/pagemap.rst b/Documentation/admin-guide/mm/pagemap.rst new file mode 100644 index 000000000000..577af85beb41 --- /dev/null +++ b/Documentation/admin-guide/mm/pagemap.rst @@ -0,0 +1,201 @@ +.. _pagemap: + +============================= +Examining Process Page Tables +============================= + +pagemap is a new (as of 2.6.25) set of interfaces in the kernel that allow +userspace programs to examine the page tables and related information by +reading files in ``/proc``. + +There are four components to pagemap: + + * ``/proc/pid/pagemap``. This file lets a userspace process find out which + physical frame each virtual page is mapped to. It contains one 64-bit + value for each virtual page, containing the following data (from + ``fs/proc/task_mmu.c``, above pagemap_read): + + * Bits 0-54 page frame number (PFN) if present + * Bits 0-4 swap type if swapped + * Bits 5-54 swap offset if swapped + * Bit 55 pte is soft-dirty (see + :ref:`Documentation/admin-guide/mm/soft-dirty.rst <soft_dirty>`) + * Bit 56 page exclusively mapped (since 4.2) + * Bits 57-60 zero + * Bit 61 page is file-page or shared-anon (since 3.5) + * Bit 62 page swapped + * Bit 63 page present + + Since Linux 4.0 only users with the CAP_SYS_ADMIN capability can get PFNs. + In 4.0 and 4.1 opens by unprivileged fail with -EPERM. Starting from + 4.2 the PFN field is zeroed if the user does not have CAP_SYS_ADMIN. + Reason: information about PFNs helps in exploiting Rowhammer vulnerability. + + If the page is not present but in swap, then the PFN contains an + encoding of the swap file number and the page's offset into the + swap. Unmapped pages return a null PFN. This allows determining + precisely which pages are mapped (or in swap) and comparing mapped + pages between processes. + + Efficient users of this interface will use ``/proc/pid/maps`` to + determine which areas of memory are actually mapped and llseek to + skip over unmapped regions. + + * ``/proc/kpagecount``. This file contains a 64-bit count of the number of + times each page is mapped, indexed by PFN. + + * ``/proc/kpageflags``. This file contains a 64-bit set of flags for each + page, indexed by PFN. + + The flags are (from ``fs/proc/page.c``, above kpageflags_read): + + 0. LOCKED + 1. ERROR + 2. REFERENCED + 3. UPTODATE + 4. DIRTY + 5. LRU + 6. ACTIVE + 7. SLAB + 8. WRITEBACK + 9. RECLAIM + 10. BUDDY + 11. MMAP + 12. ANON + 13. SWAPCACHE + 14. SWAPBACKED + 15. COMPOUND_HEAD + 16. COMPOUND_TAIL + 17. HUGE + 18. UNEVICTABLE + 19. HWPOISON + 20. NOPAGE + 21. KSM + 22. THP + 23. BALLOON + 24. ZERO_PAGE + 25. IDLE + + * ``/proc/kpagecgroup``. This file contains a 64-bit inode number of the + memory cgroup each page is charged to, indexed by PFN. Only available when + CONFIG_MEMCG is set. + +Short descriptions to the page flags +==================================== + +0 - LOCKED + page is being locked for exclusive access, e.g. by undergoing read/write IO +7 - SLAB + page is managed by the SLAB/SLOB/SLUB/SLQB kernel memory allocator + When compound page is used, SLUB/SLQB will only set this flag on the head + page; SLOB will not flag it at all. +10 - BUDDY + a free memory block managed by the buddy system allocator + The buddy system organizes free memory in blocks of various orders. + An order N block has 2^N physically contiguous pages, with the BUDDY flag + set for and _only_ for the first page. +15 - COMPOUND_HEAD + A compound page with order N consists of 2^N physically contiguous pages. + A compound page with order 2 takes the form of "HTTT", where H donates its + head page and T donates its tail page(s). The major consumers of compound + pages are hugeTLB pages + (:ref:`Documentation/admin-guide/mm/hugetlbpage.rst <hugetlbpage>`), + the SLUB etc. memory allocators and various device drivers. + However in this interface, only huge/giga pages are made visible + to end users. +16 - COMPOUND_TAIL + A compound page tail (see description above). +17 - HUGE + this is an integral part of a HugeTLB page +19 - HWPOISON + hardware detected memory corruption on this page: don't touch the data! +20 - NOPAGE + no page frame exists at the requested address +21 - KSM + identical memory pages dynamically shared between one or more processes +22 - THP + contiguous pages which construct transparent hugepages +23 - BALLOON + balloon compaction page +24 - ZERO_PAGE + zero page for pfn_zero or huge_zero page +25 - IDLE + page has not been accessed since it was marked idle (see + :ref:`Documentation/admin-guide/mm/idle_page_tracking.rst <idle_page_tracking>`). + Note that this flag may be stale in case the page was accessed via + a PTE. To make sure the flag is up-to-date one has to read + ``/sys/kernel/mm/page_idle/bitmap`` first. + +IO related page flags +--------------------- + +1 - ERROR + IO error occurred +3 - UPTODATE + page has up-to-date data + ie. for file backed page: (in-memory data revision >= on-disk one) +4 - DIRTY + page has been written to, hence contains new data + i.e. for file backed page: (in-memory data revision > on-disk one) +8 - WRITEBACK + page is being synced to disk + +LRU related page flags +---------------------- + +5 - LRU + page is in one of the LRU lists +6 - ACTIVE + page is in the active LRU list +18 - UNEVICTABLE + page is in the unevictable (non-)LRU list It is somehow pinned and + not a candidate for LRU page reclaims, e.g. ramfs pages, + shmctl(SHM_LOCK) and mlock() memory segments +2 - REFERENCED + page has been referenced since last LRU list enqueue/requeue +9 - RECLAIM + page will be reclaimed soon after its pageout IO completed +11 - MMAP + a memory mapped page +12 - ANON + a memory mapped page that is not part of a file +13 - SWAPCACHE + page is mapped to swap space, i.e. has an associated swap entry +14 - SWAPBACKED + page is backed by swap/RAM + +The page-types tool in the tools/vm directory can be used to query the +above flags. + +Using pagemap to do something useful +==================================== + +The general procedure for using pagemap to find out about a process' memory +usage goes like this: + + 1. Read ``/proc/pid/maps`` to determine which parts of the memory space are + mapped to what. + 2. Select the maps you are interested in -- all of them, or a particular + library, or the stack or the heap, etc. + 3. Open ``/proc/pid/pagemap`` and seek to the pages you would like to examine. + 4. Read a u64 for each page from pagemap. + 5. Open ``/proc/kpagecount`` and/or ``/proc/kpageflags``. For each PFN you + just read, seek to that entry in the file, and read the data you want. + +For example, to find the "unique set size" (USS), which is the amount of +memory that a process is using that is not shared with any other process, +you can go through every map in the process, find the PFNs, look those up +in kpagecount, and tally up the number of pages that are only referenced +once. + +Other notes +=========== + +Reading from any of the files will return -EINVAL if you are not starting +the read on an 8-byte boundary (e.g., if you sought an odd number of bytes +into the file), or if the size of the read is not a multiple of 8 bytes. + +Before Linux 3.11 pagemap bits 55-60 were used for "page-shift" (which is +always 12 at most architectures). Since Linux 3.11 their meaning changes +after first clear of soft-dirty bits. Since Linux 4.2 they are used for +flags unconditionally. |