drm/msm/a6xx: Make GMU reset useful

Now that the GX domain is sorted we can wire up a working GMU reset.
IF a GMU hang was detected then try to forcefully shut down the GMU
in the power down sequence which should ensure that it can recover
normally on the next power up.

Signed-off-by: Jordan Crouse <jcrouse@codeaurora.org>
Signed-off-by: Rob Clark <robdclark@chromium.org>

1 files changed, 53 insertions, 59 deletions

diff --git a/drivers/gpu/drm/msm/adreno/a6xx_gmu.c b/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
index f804cfe7407c..b3bc2a5c28e6 100644
--- a/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
+++ b/drivers/gpu/drm/msm/adreno/a6xx_gmu.c
@@ -10,6 +10,24 @@
 #include "a6xx_gpu.h"
 #include "a6xx_gmu.xml.h"
 
+static void a6xx_gmu_fault(struct a6xx_gmu *gmu)
+{
+	struct a6xx_gpu *a6xx_gpu = container_of(gmu, struct a6xx_gpu, gmu);
+	struct adreno_gpu *adreno_gpu = &a6xx_gpu->base;
+	struct msm_gpu *gpu = &adreno_gpu->base;
+	struct drm_device *dev = gpu->dev;
+	struct msm_drm_private *priv = dev->dev_private;
+
+	/* FIXME: add a banner here */
+	gmu->hung = true;
+
+	/* Turn off the hangcheck timer while we are resetting */
+	del_timer(&gpu->hangcheck_timer);
+
+	/* Queue the GPU handler because we need to treat this as a recovery */
+	queue_work(priv->wq, &gpu->recover_work);
+}
+
 static irqreturn_t a6xx_gmu_irq(int irq, void *data)
 {
 	struct a6xx_gmu *gmu = data;
@@ -21,8 +39,7 @@ static irqreturn_t a6xx_gmu_irq(int irq, void *data)
 	if (status & A6XX_GMU_AO_HOST_INTERRUPT_STATUS_WDOG_BITE) {
 		dev_err_ratelimited(gmu->dev, "GMU watchdog expired\n");
 
-		/* Temporary until we can recover safely */
-		BUG();
+		a6xx_gmu_fault(gmu);
 	}
 
 	if (status &  A6XX_GMU_AO_HOST_INTERRUPT_STATUS_HOST_AHB_BUS_ERROR)
@@ -46,8 +63,7 @@ static irqreturn_t a6xx_hfi_irq(int irq, void *data)
 	if (status & A6XX_GMU_GMU2HOST_INTR_INFO_CM3_FAULT) {
 		dev_err_ratelimited(gmu->dev, "GMU firmware fault\n");
 
-		/* Temporary until we can recover safely */
-		BUG();
+		a6xx_gmu_fault(gmu);
 	}
 
 	return IRQ_HANDLED;
@@ -166,10 +182,8 @@ static bool a6xx_gmu_check_idle_level(struct a6xx_gmu *gmu)
 }
 
 /* Wait for the GMU to get to its most idle state */
-int a6xx_gmu_wait_for_idle(struct a6xx_gpu *a6xx_gpu)
+int a6xx_gmu_wait_for_idle(struct a6xx_gmu *gmu)
 {
-	struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
-
 	return spin_until(a6xx_gmu_check_idle_level(gmu));
 }
 
@@ -568,7 +582,7 @@ static int a6xx_gmu_fw_start(struct a6xx_gmu *gmu, unsigned int state)
 		if (!rpmh_init) {
 			a6xx_gmu_rpmh_init(gmu);
 			rpmh_init = true;
-		} else if (state != GMU_RESET) {
+		} else {
 			ret = a6xx_rpmh_start(gmu);
 			if (ret)
 				return ret;
@@ -657,10 +671,9 @@ static void a6xx_gmu_irq_disable(struct a6xx_gmu *gmu)
 	gmu_write(gmu, REG_A6XX_GMU_GMU2HOST_INTR_MASK, ~0);
 }
 
-int a6xx_gmu_reset(struct a6xx_gpu *a6xx_gpu)
+/* Force the GMU off in case it isn't responsive */
+static void a6xx_gmu_force_off(struct a6xx_gmu *gmu)
 {
-	struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
-	int ret;
 	u32 val;
 
 	/* Flush all the queues */
@@ -681,44 +694,6 @@ int a6xx_gmu_reset(struct a6xx_gpu *a6xx_gpu)
 		(val & 1), 100, 10000);
 	gmu_poll_timeout(gmu, REG_A6XX_RSCC_TCS3_DRV0_STATUS, val,
 		(val & 1), 100, 1000);
-
-	/*
-	 * Depending on the state of the GMU at this point the GX domain might
-	 * have been left on. Hardware sequencing rules state that the GX has to
-	 * be turned off before the CX domain so this is that one time that
-	 * that calling pm_runtime_put_sync() is expected to do something useful
-	 * (turn off the headswitch)
-	 */
-	if (!IS_ERR(gmu->gxpd))
-		pm_runtime_put_sync(gmu->gxpd);
-
-	/* Disable the resources */
-	clk_bulk_disable_unprepare(gmu->nr_clocks, gmu->clocks);
-	pm_runtime_put_sync(gmu->dev);
-
-	/* Re-enable the resources */
-	pm_runtime_get_sync(gmu->dev);
-
-	/* Use a known rate to bring up the GMU */
-	clk_set_rate(gmu->core_clk, 200000000);
-	ret = clk_bulk_prepare_enable(gmu->nr_clocks, gmu->clocks);
-	if (ret)
-		goto out;
-
-	a6xx_gmu_irq_enable(gmu);
-
-	ret = a6xx_gmu_fw_start(gmu, GMU_RESET);
-	if (!ret)
-		ret = a6xx_hfi_start(gmu, GMU_COLD_BOOT);
-
-	/* Set the GPU back to the highest power frequency */
-	__a6xx_gmu_set_freq(gmu, gmu->nr_gpu_freqs - 1);
-
-out:
-	if (ret)
-		a6xx_gmu_clear_oob(gmu, GMU_OOB_BOOT_SLUMBER);
-
-	return ret;
 }
 
 int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
@@ -731,6 +706,8 @@ int a6xx_gmu_resume(struct a6xx_gpu *a6xx_gpu)
 	if (WARN(!gmu->mmio, "The GMU is not set up yet\n"))
 		return 0;
 
+	gmu->hung = false;
+
 	/* Turn on the resources */
 	pm_runtime_get_sync(gmu->dev);
 
@@ -789,11 +766,9 @@ bool a6xx_gmu_isidle(struct a6xx_gmu *gmu)
 	return true;
 }
 
-int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
+/* Gracefully try to shut down the GMU and by extension the GPU */
+static void a6xx_gmu_shutdown(struct a6xx_gmu *gmu)
 {
-	struct adreno_gpu *adreno_gpu = &a6xx_gpu->base;
-	struct msm_gpu *gpu = &adreno_gpu->base;
-	struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
 	u32 val;
 
 	/*
@@ -803,10 +778,13 @@ int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
 	val = gmu_read(gmu, REG_A6XX_GPU_GMU_CX_GMU_RPMH_POWER_STATE);
 
 	if (val != 0xf) {
-		int ret = a6xx_gmu_wait_for_idle(a6xx_gpu);
+		int ret = a6xx_gmu_wait_for_idle(gmu);
 
-		/* Temporary until we can recover safely */
-		BUG_ON(ret);
+		/* If the GMU isn't responding assume it is hung */
+		if (ret) {
+			a6xx_gmu_force_off(gmu);
+			return;
+		}
 
 		/* tell the GMU we want to slumber */
 		a6xx_gmu_notify_slumber(gmu);
@@ -838,14 +816,30 @@ int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
 
 	/* Tell RPMh to power off the GPU */
 	a6xx_rpmh_stop(gmu);
+}
+
+
+int a6xx_gmu_stop(struct a6xx_gpu *a6xx_gpu)
+{
+	struct a6xx_gmu *gmu = &a6xx_gpu->gmu;
+	struct msm_gpu *gpu = &a6xx_gpu->base.base;
+
+	/*
+	 * Force the GMU off if we detected a hang, otherwise try to shut it
+	 * down gracefully
+	 */
+	if (gmu->hung)
+		a6xx_gmu_force_off(gmu);
+	else
+		a6xx_gmu_shutdown(gmu);
 
 	/* Remove the bus vote */
 	icc_set_bw(gpu->icc_path, 0, 0);
 
 	/*
-	 * Mark the GPU power domain as off. During the shutdown process the GMU
-	 * should actually turn off the power so this is really just a
-	 * houskeeping step
+	 * Make sure the GX domain is off before turning off the GMU (CX)
+	 * domain. Usually the GMU does this but only if the shutdown sequence
+	 * was successful
 	 */
 	if (!IS_ERR(gmu->gxpd))
 		pm_runtime_put_sync(gmu->gxpd);